Turning on the shower is a simple thing to do but all of us face the problem of turning a shower in a hotel or a new place.You know that the buttons control the shower head. There are three different types of buttons such as single, double and triple. So how do you turn on the shower? Let us discuss
What way to turn on shower
In the below mentioned ways you can turn the shower head.
Having three buttons on your shower head gives you three different benefits.You should turn on the third button to get straight water Many bathrooms have a faucet that needs to be pulled. The diverting valve helps users get water directly, so you don’t get cold or hot water from this faucet. If you can find the valve under the faucet, better pull it. You can sometimes find it with two buttons as opposed to three buttons. So you should check it and turn on the shower head
Tub shower combination
Some showers, especially tub- shower combination showers, have a lever handle for temperature control. They also have draw cards on tap. When you turn on the water, it just seems to flow in the tub. There are a few steps you need to follow to enable these showers.
- Turn on the water with the lever and let it run into the tub.
- Then adjust the temperature to your liking. Now pull the tab on the top of the faucet.
- Now the water flow is directed from the bath to the shower head.
Showers without any indication
In some showers there is no sign of the pull tab. But don’t worry, it’s actually under the faucet where the water is dispensed. Here’s how to operate the shower.
- Turn on the water
- Change the water temperature as desired.
- Pull the tab under the faucet.
- Pulling the tab while the water is flowing can be difficult. In this case, turn it off and then pull the tab.
- Now the water flow must be directed to the shower head. Be careful how much pressure you apply when pulling these tabs. Excessive force may cause the shower cable to fall.
Electric showers
- Turning on the electric shower may vary depending on your model.
- The red power switch is usually located outside the bathroom so you don’t touch it with wet hands.
- Turn on the power.
- If there is a cord near the shower, pull it to turn it on.
- Adjust the temperature and water pressure.
Why three buttons on showers
Showers with three buttons are one of the simplest. The two buttons are of course for hot and cold water. The third button actually controls the water flow. The flow of water is directed into the bath when you turn it on the shower head in one direction and in the opposite direction. Turning all three knobs one by one is to check if they affect the temperature or direction of the water.
The functionality of shower head
The Function of the shower varies and generally depends upon:
- The model of PVC pipe is used in the piping. The multi-adjustable shower head, you can change the amount of flow.
- The best multi-controllers have more than a dozen settings available, including mist, massage and pulse shower heads.
- Adjust the flow to your liking by turning the small knob on the shower head. With each turn, you get different sprays from the shower head. Starting the shower is easy to use
Turn on Shower in Hotel
A visit to a luxurious hotel can sometimes become embarrassing as you are unable to turn the shower in the hotel. Don’t worry just follow the below steps:
- You see the knob of a temperature metre.
- After that, you need to turn the knob right side for cold water and left side for hot water, and the zero position for direct
- Turn the knob, you will get colder or more hot water from the shower head.
- Turn the knob smoothly to get the perfect shower
Different reasons for shower still not starting
If your shower won’t still start, make sure the main water valve is open and check the pipes for leaks. If you are using a power shower, make sure the power switch is on or pull the cord. In a three-button shower, the third button directs the water to the shower head. If it has a diverter valve, pull it. There can be a variety of reasons why you can’t turn your shower. Some of the most common are:
Leaks
- Many water leaks occur in plumbing pipes, faucets, and toilets. A water heater tank itself, as well as the lines connected to a shower, can also develop holes. Ultimately, this will lead to your shower not working properly.
- Leaks are only some of the common culprits behind malfunctioning of showers
Heating Rod issue
- A heating rod is used to attract oxidising elements that would otherwise rust the inside of the water heater tank.
- Leaving a bad rod inside the tank will cause the internal lining of the tank to corrode.
- The longer it takes you to replace that depleted rod, the sooner your heater will fail. During this time, you’ll notice shower issues, such as foul-smelling or rust-coloured water.
Clogging Water Supply Lines
- Minerals, such as calcium and magnesium, can settle at the bottom of your water heater tank. They can also accumulate on the internal surfaces of the pipes that supply water to your shower.
- One of the signs of hard water mineral build-up is having low water pressure in the shower. No water from the shower at all usually signals completely clogged tanks or water lines.
Faulty Shower Valve
- A shower not turning on properly can be due to a broken shower valve or valve cartridge. Shower valves, after all, control both the flow and temperature of water in the shower.
- This is the component of your shower responsible for mixing hot and cold water.
- If your shower won’t turn on or if you only get either hot or cold water, it likely means you have a broken valve.
Non availability of hot water
- The pressure of water is good in your shower but still you aren’t getting hot water when you are turning on your shower. Then there is a problem with your heater or pipe that is giving hot water to the shower
- Check out the power points whether it is working or not
- Check the fuse
- Check the heating rod
With so many reasons for your showers being unable to be turned on and you aren’t able to fix it by yourself then it is
always better to take professional help when:
- If your shower is flowing too much of very hot water
- A faulty shower needs to be replaced immediately for the safety of yours and the family.
DIY – How to Turn on Shower
Tightening Helps in turning on shower
When your shower won’t turn on, the first thing to do.
- Cut the water supply
- Try tightening the shower handle screw.
- Take a flat-blade screwdriver and use it to pry underneath the cover plate. This will reveal the faucet’s handle
- Tighten the handle screw.
- Turn on your water supply and check whether the water is flowing out through your shower.
Removing the Cartridge
If tightening the handle screw doesn’t work, then the problem is likely with the cartridge. To fix this:
- Make sure to turn off the water supply.
- Close your shower’s drain.
- Remove the handles.
- Use your screwdriver and look for the small screw and remove it.
- Remove the screw that keeps the cartridge and the turning plastic device in place.
- Look for the clip that holds the cartridge and remove it as well.
- After removing the clip, you can take out the cartridge.
Installing a new Cartridge
After successfully removing the old cartridge, you can now install the new one.Before inserting the new cartridge, make sure the hot and cold sections line up the same way as you removed the old one. Slowly slide the cartridge in then reassemble all the other pieces.
Make sure to tighten all the screws before turning the water back to test your shower faucet. Turn the faucet on and off and see if everything’s back to normal.
Conclusion
Keep it simple, if you aren’t able to figure out how to turn the shower system. Rotate the available knobs and follow the above discussed steps and your shower will definitely turn on.
Frequently Asked Questions (FAQs)
How to turn on a 3 knob shower?
Shower with 3 knobs may look complicated but are very easy to operate.
- First Knob- For cold water
- Second Knob – For hot water
- Third knob – For controlling the water flow
Can water pressure be increased by changing the shower head?
Yes, You can increase the water pressure by getting a new high pressure shower head which is easily available in the market.
